| |
|
|
|
| |
Product Details |
|
|
| |
Type |
: |
Bare Water Tube, IBR |
| |
Installation |
: |
Horizontal / Vertical, Indoor as well as Outdoor. |
| |
Tube Orientation |
: |
Horizontal / Vertical |
| |
Waste gas flow direction |
: |
Horizontal + Vertical (upwards & downwards) |
| |
Quality of waste gases |
: |
Gases having low to high dust load special design for high
dust. |
| |
Acceptable dust in waste gases |
: |
High dust level acceptable for Boilers having mechanized
soot and collecting facility. |
| |
Type of heat recovery output |
: |
Steam (D & S / Superheated), Hot Thermic Fluid, Hot Water |
| |
Media of Waste heat |
:
|
Hot gases, hot bulk powders, hot liquids, hot vapours |
| |
Steam pressure |
: |
Suitable for low as well as high pressure |
| |
Steam condition |
: |
Dry & saturated and also superheated steam through provision
of superheater. |
| |
Water side circulation |
: |
Once through, Natural Circulation & Forced / Assisted
circulation. |
| |
Steam separation |
: |
In
steam drum or in external moisture separator. |
| |
Waste heat source suitability |
: |
Fuel cell exhaust, Micro / miniturbine exhaust, Gas turbine
exhaust, DG set exhaust process waste gases, Incinerator
exhaust, furnace exhaust. |
| |
Typical applications |
: |
Exhaust of steel furnaces, cement kilns, metal smelters,
Incinerators, Industrial furnaces, DG set exhaust, process
waste gases, Incinerator exhaust, furnace exhaust, gas
turbine exhaust. |
| |
Duct Firing possibilities |
: |
Possible for applications on gas turbine exhaust. Heat
addition into waste gas stream by addition of hot gases
generated by separately fired hot gas generator. |
| |
Output capacity possibilities |
: |
No
Limits |
| |
Soot removal |
: |
1)
Mechanized vibrating soot removal.
2) Travelling type
soot blower.
3) Rotary soot
blower. |
| |
Number of heat recovery stages possible |
:
|
3
to 4 stages of heat recovery possible e.g. super heater,
evaporator, economizer, water preheater. |
| |
Typical lowest exhaust gas temperature at final outlet of
system. |
: |
Gases generated by diesel - 130 Deg.C, gas generated by
natuaral gas - 110 Deg.C, gases generated by high sulphur
fuels - 150 Deg.C |
| |
Protection against sulphur corrosion on cold end side |
: |
Provided by various means to ensure that metal temperature
is maintained above the actual incipient limit. |
.jpg){kind=small}
